Description
Typical ATV Starlink installation kits in situ. Ideally, when using pairs of brackets, they should be well spaced.
WC(RA) Starlink wall install kit with 6ft right angle cranked pole
Note : Ideally one should aim for minimum movement of the Starlink dish. Asking any pole installation to be totally free of movement in any conditions becomes increasingly difficult as the pole gets longer and the stand off greater. Use of a right angle crank pole with a 21″ off-set (particularly with a large stand off bracket) will not be as rigid as, say, a WS kit (or even a WCL kit). But the only other option to get 32″ of stand off would be to use a straight pole with a pair of 36″ T&Ks, which are huge, heavy, unsightly and expensive…..
When using pairs of brackets the farther apart they are mounted the stronger the install will be.
The kit comprises :
– (optional – for Mk3 Starlink) 1.5″ pole adapter.
The adapter can be bought separately here.
– (optional – for Mk1 or Mk2 Starlink) 1.5″ pole coupler.
The pole coupler can be bought separately here.
– 6ft x 1.5 inch x 1.6mm (16G) “right angle” cranked alloy pole.
– Pair of Low Profile brackets (hot dip galv pressings – finish may vary – and Nyloc stainless bolts).
OR a pair of welded 6″x9″ hot dip galvanised wall brackets – finish may vary – c/w Nyloc stainless steel V bolts with hot dip galvanised saddles.
OR a single heavy duty welded hot dip galvanised wall bracket (either 12″x12″ or 12″x18″) c/w Nyloc stainless steel V bolts with hot dip galvanised saddles.
– Eight (or four with the single brackets) stainless steel (A2) wall bolts and washers with universal plugs.
– 1m of self amalgamating tape (only supplied with the coupler).
– Box of 100 black 7mm clips
– Screw eye (see safe use of a ladder)
NOTE : When installing an aerial or a satellite dish on pole you would almost always install the item on the pole then install the pole on the bracket, unless the top of the pole was very easily accessible (which it isn’t usually).
Customers’ Starlink install reports.
Unfortunately we cannot ship this kit out of the UK.
The Low Profile Brackets in our Starlink install kits have Nyloc nuts.
A pair of brackets are supplied (6×9, the 6×6 is not available with this kit) or a single (12×12 or 12×18), either wall brackets (as below, with one or two pairs of stainless V bolts as required) or Low Profile brackets (as above, hot dip galvanised & stainless steel bolts).
Note : The V bolts in this kit are supplied with saddles due to the larger twisting forces caused by the 21″ offset right angle cranked pole.
Product appearance may vary
The screws supplied in our Starlink install kits are coach screws, as below.
So you don’t have to hold the clip on the cable and risk Derrick the Decider (the II) hitting your fingers.
